Posted in AudioCodes, Skype for Business

Wondering how to configure FXS analog port in just few minutes? Here’s How.

If you want to configure your FXS analog extensions without any special configurations, here how I do it. It will simply ring each port’s extension.

Scenario:

I have AudioCodes Mediant 1000 with 4 FXS analog ports attached to it. I simply want to ring each port. I use 5001, 5002, 5003, 5004 extension respectively. Configuration of digital interface is not part of this post.

fxs_1

Directly go to Trunk group and configure below:

fxs_2

Configure Trunk Group Settings as below:

fxs_3

Configure the Tel to IP routing.

This route is basically the call from analog ports to M1K IP address.

  • Source number: Any
  • Destination number: 5xxx# (4 digits start with 5)
  • Destination IP address: 172.16.0.41 (AC M1K IP address)
  • Destination Port: 5060 (This was my Destination Port configured in SIP General Parameters)

fxs_4

Configure the IP to Trunk Group Routing.

This route is from AC M1K IP address to analog ports.

  • Source number: Any
  • Destination Prefix: 5xxx#
  • Destination Trunk Group: 2

fxs_5

No need to configure anything at manipulation table.

Verification:

Call from 5001 to 5002 was indeed working and was able to answer.

fxs_6

That’s it!!!

Easy. Isn’t it? 🙂

Hope it helped you!